Flare edge clamping tab
- Material: Spring steel
- Surface: Zinc plated
* Incl. VAT excl. Shipping
A continuous tensile load may only be applied with diagonal pull at an angle of at least 10° to the pin axis.
The flare edge clamping pin is used in concrete (> C35/45), solid brick, solid sand-lime brick and pressure-resistant natural stone as well as for insulation and slatting. It braces across the entire length in the drill hole.
Push-through installation
Create the drill hole (observe the recommended diameter exactly!)
Clean the drill hole
Hammer in clamping pin
A continuous tensile load must only be applied with diagonal pull at an angle of at least 10° to the pin axis.
- Material: Spring steel
- Surface: Zinc plated